Table of Contents
Advertisement
c. When you have selected "Barcode Single" or "Barcode Multi", you have to decide if the job
has to be performed only once ("Single Scan") or multiple times ("Multi Scan").
> Single Scan: The command will be given to start scanning the bar code of the first / next
reference box ONLY, from roll or sheet. After finishing this single job, the SC-Pro returns
into the Ready status.
> Repeat Mode: AUTOMATICALLY all succeeding frames will be scanned and contour cut
as well, until the end of roll is reached.
C o n t o u r c u t t i n g
S i n g l e s c a n
M u l t i s c a n
S t a r t :
Step 5 :
When all settings have been made, press the [ ]-key to start measuring the frame.
a. In case you have selected Barcode Single or Barcode Multi, the cutter will automatically
measure the complete reference box.
b. In case you have selected Manual alignment, you will have to manually select the alignment
points (corners) of the frame.
The EPOS laser will light up.
►
The laser moves to the first corner (P1). Use the
►
arrow keys to position the laser exactly in the
centre of the cross and press the [ENTER]-key.
The laser will move automatically to point 2, than
►
point 4 and finally point 3. Position the laser each
time in the centre of the cross and press the
[ENTER]-key.
When measuring the four points of the reference box and the cutter establishes a distortion
(this means the reference box is not a perfect rectangle due to print deformation, or not
between the margins), the cutter will beep and shows following message:
To continue:
To stop:
The cutter will cut a little cross in the lower right corner to remind you to its bad print quality
in case of bad contour cutting.
Step 6 :
The alignment has been done.
Notes
E x i t :
Notes
Much print
distortion
User's Guide SC-PRO Cutting Plotter
82
CHAPTER 6 : CONTOURCUTTING
P4
P2
P3
P1
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
