Table of Contents
Advertisement
CONTOUR CUTTING is a very popular feature of the SC PRO cutter.
This feature is made to cut pre-printed signs on vinyl for sticker
production as shown on this picture
Please read this chapter carefully. Because of the importance of this
feature, almost a complete manual is written about it. So please refer to
the Application Guide for all necessary information.
The information below is some basic information about the different
alignment methods ...
6.1 DIFFERENT ALIGNMENT METHODS
There are some different approaches to cut your signs which also implicate a different alignment method.
1. Manual
2. Auto No BC
(only selectable via
the cut software)
3. Barcode Single
4. Barcode Multi
Manual
P4
P2
P3
P1
6 CONTOUR CUTTING
►
►
►
Manual alignment method.
Manually set the size of the paper and 4 corners of the box.
o
Automatic alignment method without barcode
Automatic measurement of the reference box (job data).
o
Only 1 box
o
Automatic alignment with barcode and single frame
Automatic measurement of the reference box and barcode (job data).
o
Only 1 reference box
o
Automatic alignment with barcode and multi-segment frame.
Automatic measurement of the reference box and barcode (job data).
o
Multiple segments in 1 reference box (for long files to guarantee precision).
o
Auto No BC
User's Guide SC-PRO Cutting Plotter
►
►
►
BCode Single
0000000000000
75
CHAPTER 6 : CONTOURCUTTING
BCode Multi
0000000000000
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
