Table of Contents
Advertisement
4.2.23
Serial communication
In order for your plotter to be able to communicate well with your host computer, the communication settings
on both machines have to match exactly. Please refer to the manual of your software to determine which
communication setting will be used by your software.
necessary.
To change the communication selection, please follow the instructions mentioned below:
Step 1 :
Select with the
B a u d r a t e
D a t a B i t s
P a r i t y
S t o p B i t s
F l o w C o n t r o l
R S 2 3 2 / U S B / E T H
Step 2 :
Press the [ ] – key to confirm your selection.
Step 3 :
Change the value with the
Step 4 :
Return to the main menu of the serial communication settings and change all the other settings if
necessary.
The following settings can be made.
Baudrate
DataBits
Parity
StopBits
FlowControl
RS232/USB/ETH
- keys the setting you want to change.
- keys and confirm once again with the [ ] – key.
1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600 or 115200
7 or 8
None, even or odd
0, 1 or 2
Software or hardware
Auto, Serial, USB or Ethernet connection
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
Your cutter can be set up to use any settings
56
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
