Table of Contents
Advertisement
4.2.1
Sheet off mode
The auto-sheet-off mechanism of your cutter can be very easily used to cut the front edge of a new roll of
vinyl straight as well as to cut off a sheet of vinyl from a roll, to be used as a separate sheet.
With the sheet-off mode, you can select "AUTOMATIC", "MANUAL" or "DISABLE".
Sheetoff Mode
AUTOMATIC
MANUAL
DISABLE
4.2.2
Sheet off margin
It is sometimes useful that the media is fed an amount of millimetres after a job, before sheeting off.
Sheetoff Margin
1 – 5 – 250 [mm]
4.2.3
Auto Shuffle
Set if it is necessary to perform an automatic media shuffle after a sheet-off procedure.
Auto Shuffle
ENABLED
Disabled
S h e e t o f f M o d e
A U T O M A T I C
S a v e :
E x i t :
A sheet-off will be done automatically when pressing the
sheet-off key.
A sheet-off can be done with a snap-off blade knife; the media will
feed towards the cut groove after a job is done.
No sheet-off possible.
S h e e t o f f M a r g i n
5
[ m m ]
S a v e :
E x i t :
The media will be fed 5 mm extra before sheeting off.
S h e e t o f f M o d e
A U T O M A T I C
S a v e :
E x i t :
An automatic shuffle will be executed after a sheet-off
No automatic shuffle will be executed after a sheet-off
46
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
