Table of Contents
Advertisement
3.1.2
Replace cutter blade
To replace a blade, please proceed as follows:
STANDARD KNIFE HOLDER
Step 1 : Hold the body (2) into one hand and
unscrew the base part (1)
Step 2 : Remove the spring (3) and the cutting
blade (4).
Step 3 : Slide the spring over the new cutting
blade
Step 4 : Place the new blade with its spring into
the base part and screw the whole
assembly onto the body.
User's Guide SC-PRO Cutting Plotter
KNIFE HOLDER WITH NONIUS
Step 1 : Take the body into one hand and remove
the base part
Step 2 : Pull the old blade out of the holder and
insert a new one
Step 3 : Place the base part on top of the holder
assembly and twist it tightly.
22
CHAPTER 3 : BASICS
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
