Table of Contents
Advertisement
EPOS problem:
It might also be possible that the reference box
►
No EPOS reference
cannot be found.
found
The EPOS sensor is broken
►
EPOS problem:
►
Movement failed
EPOS problem:
►
Barcode problem
occured
EPOS problem:
►
EPOS aligning aborted
Not enough pressure
One of the pressure rollers is not used or is
►
rolls detected
pushed to the far left.
The pressure roller sensor is broken
►
A movement cannot be performed because of
mechanical failures.
The barcode cannot be read/found by the
EPOS sensor on the machine
The user has cancelled the EPOS job
89
User's Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
1. Select the correct file in the Mutoh
CutServer and start the job manually
(send EPOS job)
2. Make sure that the printed reference
box is made within the specifications.
3. Be sure that the contour cutting box
is located in between the two outer
pressure rollers.
4. Be sure that the media is loaded
straight.
5. Contact an Authorized Mutoh
Technician to replace the sensor
1. Reboot the machine.
1. Is the barcode well positioned
according to the specifications?
2. The printed barcode is blurry, too big
or too small.
1. Always use pressure roller 1 and 4. Be
sure you hear a click when positioning
them above the loaded media.
Pressure roller 2 and 3 can be used
but may also be disabled (in between
two clicks).
2. Contact an Authorized Mutoh
Technician to replace the sensor
AP-75280 – Rev. 1.1
► Application Guide Print&Cut
► Contourcutting ► Square details
► Basics ► Loading media
Advertisement
Table of Contents
