Floor Loading; Moving The System And Battery Pallets - Eaton BladeUPS User Manual

Floor Loading

When planning the installation, consider the system weight for floor loading. The strength of the installation
surface must be adequate for point and distributed loadings. Approximate weights are shown in Table 1.
Table 1. Weights
Number of UPSs

Moving the System and Battery Pallets

The system is bolted to a wooden pallet supported by wood skids. The batteries are stacked on a separate pallet
and are held in place with strap binding.
To move the system:
1. Verify that the forklift or pallet jack is rated to handle the weight of the system (see Table 1 for system
weight).
2. If not already moved, use a forklift or pallet jack to move the system to the installation area, or as close as
possible. Insert the forklift jacks between the skids at the front of the pallet.
The forklift jacks must be inserted between the skids at the front of the pallet (see Figure 4). If
unloading instructions are not closely followed, moving the system may cause serious injury.
NOTE You may find it useful to use a magnetized screwdriver when removing or replacing
mounting screws.
(Pallet, Rack, Wireway, BladeUPS Bar, and UPSs)
1
2
3
4
5
6
Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 9 www.eaton.com/powerquality
Shipping Weight
471.7 kg (1040 lb)
617.8 kg (1362 lb)
763.9 kg (1684 lb)
909.9 kg (2006 lb)
1060.5 kg (2328 lb)
1202.0 kg (2650 lb)
WARNING
Preassembled System Installation
System Weight
(Excludes Pallet)
304.8 kg (672 lb)
450.9 kg (994 lb)
596.9 kg (1316 lb)
743.0 kg (1638 lb)
889.0 kg (1960 lb)
1035.1 kg (2282 lb)
18