To install the parallel system input and output wiring:
1.
Verify that all battery circuit breakers on all UPSs are in the OFF (O) position (see Figure 20).
Figure 20. BladeUPS Module Rear Panel
2.
Remove the five screws on the bottom entry wireway access cover and retain. Remove the cover and
retain (see Figure 21).
Figure 21. Removing the Wireway Access Cover (Bottom Entry Rack Shown)
Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 9 www.eaton.com/powerquality
Load
Input
(RPM) Connector
Breaker
Breaker
Preassembled System Installation
Battery
Breaker
37