Eaton BladeUPS User Manual page 38

3. Use a magnetized Phillips screwdriver to remove the trim on each side of the cabinet top panel (see
Figure 14):
- Remove and retain the four interior trim screws located on the inside of the side panel (A, B, C, and
D).
- Remove and retain the four pairs of outside trim screws located at the top on each rack (1 through 8).
- Remove and retain the top trim panels.
- Place both top trim panels and all mounting screws together in the same accessible location.
D
7
8
Figure 14. Removing the Trim Screws
NOTE Each top panel trim has three pieces, but do not disassemble it. It is attached as one
assembly.
Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 9 www.eaton.com/powerquality
C
5
6
B
Preassembled System Installation
Interior Trim crews
(A, B, C, D)
A
Top Panel Trim
3
4
Outside Trim crews
(1−8)
1
2
31