Eaton BladeUPS User Manual page 77

6. Install the UPS front cover (see Figure 58):
Plug the LCD cable from the control panel on the front cover into the connector on the electronics
module. Use care to loop the LCD cable gently in front of the electronics module.
Push the top of the front cover firmly into place, and then push the bottom firmly into place.
Figure 58. Installing the UPS Front Cover
7 . Parallel system only. Repeat the steps starting at the beginning of section "UPS Setup" on page 63 for
each UPS to be paralleled.
If installing optional EBM(s), see "EBM Installation" on page 43. 
8.
Otherwise, continue to "Standalone UPS Installation" on page 72 or "Parallel UPS Installation" on
page 75.
Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 9 www.eaton.com/powerquality
Standard System Installation
71