Eaton BladeUPS User Manual page 9

Normal operating mode that minimizes heat generation by operating typically at >98% efficiency. The UPS
l
filters incoming AC power and provides consistent power to your equipment without draining the battery.
For utility line input that exceeds normal operating range, automatic transfer to an online, double-conversion,
l
high-frequency UPS design with pure sine wave output and power-factor correction.
ABM technology that uses advanced battery management to increase battery service life, optimize
®
l
recharge time, and provide a warning before the end of useful battery life.
Hot-swappable electronics module and batteries that simplify maintenance by allowing you to replace them
l
safely without powering down the critical load.
Emergency shutdown control through the remote emergency power-off (REPO) port.
l
One standard communication option with a DB-9 serial port and two open communication bays (X-Slot) that
l
allow a number of communication options.
Firmware that is service upgradable through the DB-9 communication port.
l
Backed by worldwide agency approvals.
l
Figure 2. Standard Cabinet Used for BladeUPS
NOTE The illustrations in this document are typical, but may not be identical to your model.
Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 9 www.eaton.com/powerquality
Introduction
2