Checking The Ebm Accessories; Rack Setup For The Ebm - Eaton BladeUPS User Manual

Checking the EBM Accessories

Verify that the following items are included with the EBM:
EBM front cover
l
Mounting brackets and fasteners (if not already installed):
l
- (2) mounting brackets
- (4) 6-32 flat-head screws
Rails and fasteners:
l
- (2) sliding rail assemblies (left and right)
- (2) rear hold-down brackets
- (12) hex-head screws
- (4) U-shaped 10-32 clip nuts
EBM user's guide
l
NOTE Discard the EBM user's guide. Use this user's guide to install the EBM.

Rack Setup for the EBM

The EBM is heavy (see page 130). Removing the EBM from its carton requires a minimum of two
people. Use the corrugated lifting sling (packaged with the UPS) to move the UPS.
NOTE Mounting rails are required for each individual cabinet.
To install the EBM rail kit:
1. Loosen the assembly wing nuts on both rail assemblies and adjust the rail size for the depth of your rack
(see Figure 31).
Front
Rail Assembly
Figure 31. Adjusting the Rail Depth
Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 9 www.eaton.com/powerquality
CAUTION
Assembly Wing Nuts
Preassembled System Installation
Rear
44