Gas Tank - Arctic Cat WILDCAT/X Service Manual

INSTALLING
1. Connect the throttle cable to the throttle arm; then
install the throttle cable housing to the throttle body
and secure the throttle arm cover with the screw.
2. Make sure the alignment tab on the throttle body
aligns with the slot in the intake boot and install the
throttle body fully into the boot. Tighten the clamp to
30 in.-lb.
3. Install the wire connectors on the TPS, MAP/IAT, and
TPS; then place the air filter outlet into the throttle
body boot and tighten the clamp to 30 in.-lb. Install
the air filter housing strap.
100
WC215A
4. Remove the holding strap and move the radiator back
into position and secure with the mounting screws.
Tighten securely.
5. Secure the heat shield and rear coil to the radiator,
then install the cargo box.
6. Install the rear body panel and secure with the appro-
priate fasteners; then connect the negative battery
cable and install the battery cover and seats.
Whenever any maintenance or inspection is made on
the fuel system during which there may be fuel leakage,
there should be no welding, smoking, open flames, etc.,
in the area.
REMOVING
1. Remove the seats and battery cover; then disconnect
the negative battery cable.
WC216A
2. Remove the rear body panel and cap off or tape the
gas filler hose.
3. Remove the cargo box; then disconnect the tail/brakelight
connectors and the fuel pump/fuel level sensor connector.
4. Remove the exhaust pipe to muffler springs and
remove the muffler.
5. Pry the wiring harness anchors out of the cargo box
supports and mark any wire tie locations; then set the
harness out of the way.
WC164A

Gas Tank

! WARNING
WC206B
WC179B