Arctic Cat WILDCAT/X Service Manual page 63

B. Camshaft lobes directed down (toward the piston).
C. Camshaft alignment marks parallel to the valve
cover mating surface.
D. Recessed side of the sprocket directed toward the
cam lobes.
E. Camshaft alignment pin and sprocket alignment
hole (smallest) are aligned.
CAUTION
If any of the above factors are not as stated go back to
step 19 and carefully proceed.
23. Place tab-washer onto the sprocket making sure it
covers the pin in the alignment hole.
CAUTION
Care must be taken that the tab-washer is installed cor-
rectly to cover the alignment hole on the sprocket. If the
alignment pin falls out, severe engine damage will
result.
24. Install the first cap screw (threads coated with red
Loctite #271) securing the sprocket and tab-washer to
the camshaft. Tighten only until snug.
25. Rotate the crankshaft until the second cap screw
securing the sprocket to the camshaft can be installed;
then install the cap screw (threads coated with red
Loctite #271) and tighten to 11 ft-lb. Bend the tab to
secure the cap screw.
26. Rotate the crankshaft until the first cap screw (from
ATV-1027
step 23) can be addressed; then tighten to 11 ft-lb.
Bend the tab to secure the cap screw.
27. Place the C-rings into position in their grooves in the
cylinder heads.
GZ195
GZ193
CD465
GZ194
CC012D
61