Arctic Cat WILDCAT/X Service Manual page 40

9. Remove the two cargo box supports; then remove the
heat shield leaving the rear coil attached to the radia-
tor assembly.
10. Remove the gas tank hold-down and gas tank; then
remove the gas tank cradle.
11. Disconnect the cooling fan connectors, spark plug
wire, and coil primary connector; then clamp off the
coolant hoses at the water pump and thermostat outlet.
Do not remove the hoses yet.
38
12. Remove the radiator mounting screws; then discon-
nect the coolant hoses from the engine and remove the
radiator from the vehicle being careful not to release
WC352A
the clamps. Coolant can remain in the radiator.
13. Remove the CVT cooling outlet duct; then remove the
screws securing the air filter mounting bracket to the
CVT housing.
WC350A
WC192
WC193
WC197A
WC200A
WC201A