Installing Right-Side Components - Arctic Cat WILDCAT/X Service Manual

2. Remove the snap ring securing the bearing in the
water pump drive cover; then remove the bearing
using an appropriate blind bearing remover.
Inspecting
1. Inspect the water pump drive housing (A) for scoring
or discoloration.
2. Inspect the bearing (B) for smooth rotation and no dis-
coloration or scoring.
3. Inspect the gear (C) for chipped or missing teeth,
excessive hub wear, or excessive wear in the drive pin
slot.
4. Inspect the drive pin (D) and driveshaft (E) for exces-
sive wear or looseness.
Assembling
1. Install the bearing in the water pump drive cover and
secure with the snap ring (flat side away from the
bearing).
GZ442
2. Install the gear onto the driveshaft noting correct ori-
entation (from step 1 of disassembling).
3. Install the two snap rings on the driveshaft (flat side
GZ441
away from the gear).
Installing Right-Side
1. Place a new clutch housing seal (spring side facing
Clutch Housing Seal Tool) into the clutch cover and
secure with a rubber mallet or press.
GZ440A
2. Using a suitable press, install the bearing into the
clutch cover against the outer bearing face.
Components
GZ441
GZ442
GZ530
77