Arctic Cat WILDCAT/X Service Manual page 19

2. Secure the driven clutch with the cap screw (A),
washer (B), and alignment shim(s) (C); then tighten to
60 ft-lb.
WC667
3. Place the alignment pins and new gasket on the clutch
housing; then install the CVT cover/air filter bracket and
secure with the cap screws. Tighten in a crisscross pat-
tern to 8 ft-lb.
4. Connect the exhaust duct and tighten the boot clamp
securely.
5. Install the rear shock absorber and secure with the cap
screws. Tighten the upper cap screw to 40 ft-lb and the
lower cap screw to 35 ft-lb.
 NOTE: Drive belts require a break-in period (see
Break-in Procedure - Drive Belt in the General Informa-
tion Section).
WC810
Failure to properly break-in a new drive belt will result in
premature belt failure.
CAUTION
WC741A
17