Arctic Cat WILDCAT/X Service Manual page 157

2. Press the piston into the caliper housing using hand
pressure only. Completely seat the piston; then wipe
off any excessive brake fluid.
3. Apply high-temperature silicone grease (supplied with the
O-ring kit) to the inside of the caliper holder bores and O-
rings; then install the four O-rings into the caliper.
PR715
4. Install the caliper onto the caliper holder making sure
the caliper and holder are correctly oriented.
 NOTE: It is very important to apply silicone grease
to the O-rings and caliper bores prior to assembly.
PR717A
5. Making sure brake fluid does not contact the brake pads,
compress the caliper holder toward the caliper and
install the inner brake pad; then install the outer pad.
If brake pads become contaminated with brake fluid, they
must be thoroughly cleaned with brake cleaning solvent
or replaced with new pads. Failure to do so will result in
reduced braking and premature brake pad failure.
PR711A
PR712
CAUTION
PR719C
PR239C
PR238
155