Arctic Cat WILDCAT/X Service Manual page 83

3. Remove the snap ring securing the water pump idler
shaft (C) in the crankcase; then remove the shaft and
bearings.
4. Remove the snap ring securing the oil pump driven
gear (D) to the oil pump driveshaft; then remove the
gear. Account for a drive pin and washer.
5. Remove the shift fork shaft (E); then remove the gear
shift shaft assembly (F). Account for a flat washer and
a spacer.
GZ299A
6. Remove two cap screws securing the oil pump in the
crankcase and remove the oil pump.
GZ463A
7. Remove the driveshaft (G); then remove the counter-
shaft assembly (with shift forks) (H). Account for two
flat washers on the countershaft.
GZ463B
DE677A
GZ276
GZ305
GZ280B
81