Arctic Cat WILDCAT/X Service Manual page 66

AT THIS POINT

To replace stator coils/crankshaft position sensor, see
Electrical System.
2. Remove the starter motor, starter driven gear (A),
starter countershaft bushing (B), and starter counter-
shaft gear (C); then remove the starter gear shafts (D)
noting the longer shaft is nearest the starter.
 NOTE: The starter is not serviceable and must be
replaced as a complete assembly.
3. Remove the rotor/flywheel nut; then install the appro-
priate crankshaft protector into the crankshaft.
4. Install Magneto Rotor Remover Set and loosen the
rotor/flywheel; then remove the crankshaft protector
and rotor/flywheel from the crankshaft. Account for
the flywheel key.
64
GZ212A
5. With the flywheel key removed, remove the starter
ring-gear and spacer washer.
GZ224A
H2-018
6. Remove the hose clamps from the water pump; then
remove the coolant hoses from the water pump outlets
and coolant pipes.
GZ216
GZ217
GZ226
GZ249