Arctic Cat WILDCAT/X Service Manual page 96

10. Making sure the tab on the throttle body aligns and
fully engages the alignment slot on the intake boot,
install the throttle body and tighten the clamp nut to
30 in.-lb; then install the engine ground cable.
11. Connect the ECT connector (A), front coil primary
connector (B), TPS connector (C), MAP/IAT connec-
tor (D), and ISC connector (E).
94
12. Install the fuel rail with fuel injectors and secure with
the cap screws. Tighten to 6 ft-lb.
13. Connect the gas line connectors to the fuel rails and
the electrical connectors to the fuel injectors.
WC164A
14. Place the inlet air duct into position; then install the
CVT intake cooling duct and secure with the clamp.
WC210A
15. Set the air filter housing into place and secure with the
three screws on the CVT housing and tighten to 6 ft-
lb; then connect and secure the throttle body inlet air
boot (A), crankcase breather hose (B), and inlet air
duct (C). Tighten the inlet air boot clamp to 30 in.-lb
and install the air filter housing strap.
WC204A
16. Install the CVT cooling outlet duct; then with a new gra-
foil gasket, install the rear exhaust pipe and cap screws
loosely.
17. Install the radiator/fan assembly and secure with the
mounting screws; then connect and secure the coolant
hoses with the clamps. Tighten securely.
WC206A
WC203A
WC209A
WC146A