Master Cylinder Assembly - Arctic Cat WILDCAT/X Service Manual

160
3. Remove the oil bolt securing the banjo-fittings to the
master cylinder; then remove the master cylinder. Dis-
card the three crush washers.
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the vehicle.
Inspecting
1. Inspect the master cylinder push rod and clevis for
wear, bending, or elongation of clevis holes.
2. Inspect the push rod boot for tears or deterioration.
3. Inspect the reservoir for cracks and leakage.
PR338
4. Inspect the brake hose for cracks and deterioration and
the condition of the banjo-fittings.
Installing
1. Place the master cylinder into position; then using
three new crush washers, secure the two banjo-fittings
to the master cylinder. Tighten to 20 ft-lb.
2. Secure the master cylinder assembly to the frame with
two cap screws and two flange nuts. Tighten to 25 ft-lb.
3. Install the pivot pin and secure with a new cotter pin.
4. Fill the master cylinder and bleed the brake system
(see Hydraulic Brake System in Periodic Mainte-
nance/Tune-Up).
PR336
CAUTION