Arctic Cat WILDCAT/X Service Manual page 47

 NOTE: It may be necessary to use a hoist to slightly
raise the rear of the vehicle to free the link from the
frame weldment.
24. Remove two through-bolts and one cap screw secur-
ing the rear drive gear case; then reattach the lateral
link and remove the hoist if used.
25. Using a suitable engine lift and equalizer sling, sup-
port the engine; then remove the engine through-bolts,
front first followed by the rear.
WC170
26. Remove the rear drive coupler boot; then lift the
engine slightly and work the rear drive gear case and
engine rearward enough to clear the front drive cou-
pler and drop the driveshaft down.
WC170A
27. Move the engine forward sufficiently to disengage the
spline shaft on the rear drive coupler and lift the engine
just free of the mounts; then clamp off the oil cooler hoses
and disconnect from the engine.
WC169A
WC172A
WC172B
WC174
WC173
45