Gas Tank - Arctic Cat 2009 Prowler XT Service Manual

2. Turn the idle adjustment screw clockwise one turn
past the recommended RPM setting; then turn it
counterclockwise to 1250-1350 RPM.
! WARNING
Adjust the idle to the correct RPM. Make sure the
engine is at normal operating temperature before
adjusting the idle RPM.

Gas Tank

! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
REMOVING
1. Remove the seats and center console; then remove
the left-side and right-side seat-bases.
2. Remove twelve cap screws and two self-tapping
screws securing the floorboard to the frame.
3. While pulling forward on the upper portion of the
floorboard, lift the rear panel above the seat lock
studs; then insert a small wood block to hold in
position.
Back
PR081A
PR163
Back to TOC
4. From the opposite side of the vehicle, repeat step
3; then lift the rear of the floorboard up and lift the
floorboard out of the vehicle.
5. Disconnect the vent hose, gas hose, and fuel level
sensor connector; then cap the vent fitting and gas
hose fitting.
6. Remove the outer cap screw securing the front tank
hold-down; then swing the hold-down to the left.
Back to Section TOC
PR164
4
PR165
PR166B
Next
4-9