Arctic Cat WILDCAT/X Service Manual page 139

Removing/Installing Axle Seal
 NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
 NOTE: Prior to installing the seal, apply High-Per-
formance #2 Molybdenum Disulphide grease to the
seal outside diameter.
2. Using Gear Case Seal Installer Tool, evenly press the
seal into the cover bore until properly seated.
CAUTION
Make sure the tool is free of nicks or sharp edges or
damage to the seal may occur.
3. Repeat steps 1-2 for the opposite side.
INSTALLING
1. Lay the differential assembly on its right side and
place in the frame of the vehicle; then turn it upright
and maneuver into the mounting brackets.
CD110
2. Apply molybdenum grease to the splines and install
the forward driveshaft into the differential splined
coupler; then install the three Allen-head bolts in the
driveshaft coupler and tighten to 40 ft-lb.
CC899
3. Install the two through-bolts and secure the differen-
tial with new lock nuts. Tighten to 38 ft-lb.
4. On the Wildcat/X, secure the carrier bearing to the
CF278
carrier bearing support bracket with two bolts and
nuts. Tighten the nuts to 38 ft-lb.
WC277
WC267A
WC276A
137