2. Remove the Belleville washer and hub nut securing
the hub.
3. Remove the brake caliper.
4. Remove the hub assembly.
5. Remove the four cap screws securing the brake disc.
152
WC240B
WC304
Wildcat
PR243A
X/Wildcat4/4X
WC606
NOTE: It may be necessary to heat the cap screws
to loosen the Loctite.
CLEANING AND INSPECTING
1. Clean all hub components.
2. Inspect all threads for stripping or damage.
3. Inspect the brake disc (if applicable) for cracks or
warping.
4. Inspect the hub for pits, cracks, loose studs, or spline wear.
REPLACING WHEEL STUDS
1. Secure the hub in a suitable holding fixture and
remove the brake disc (if applicable).
2. Drive the damaged stud out of the hub; then place the
new stud into the hub and thread on an appropriate
flange nut.
3. Using a socket and ratchet handle, tighten the nut until
the stud is fully drawn into the hub.
PR254A
PR250
PR252A