Arctic Cat WILDCAT/X Service Manual page 108

 NOTE: If readings are erratic, clean the resistor
wiper and resistor with clean alcohol and retest. If
still not correct, replace the fuel level sensor.
4. To replace the fuel level sensor, use the following pro-
cedure.
A. Disconnect the two-wire connector (A); then press
the fuel level sensor toward the top of the fuel
pump to release it from the mounting slot (B).
B. Engage the tabs (C) of the fuel level sensor into the
mounting slot (B) and press toward the bottom of
the fuel pump to latch in place; then connect the
two-wire connector (A).
INSTALLING
1. Carefully place the fuel pump assembly into the gas
tank referencing orientation marks made during
removal.
106
ATV2116
2. Secure the pump assembly with the mounting screws
and tighten securely in a crisscross pattern.
3. Connect the electrical connector and the gasline hose
connector to the fuel pump; then press the wiring har-
ness anchors into position and secure the cable ties as
shown.
FI460A
4. Install the cargo box; then install the rear body panel
and connect the gas tank filler hose and secure with
the clamp.
5. Connect the negative battery cable and install the bat-
tery cover; then install the seats and lock in place.
WC226
WC226A
WC224A