Engine Rpm (Idle); Gas Tank - Arctic Cat Prowler Service Manual

7. Place the U-ring into the pump housing. Position
the spring and diaphragm assembly (lip toward the
carburetor) onto the carburetor; then secure the
assembly with the pump housing and three screws.
Tighten securely.
! CAUTION
It is important to press down on the pump housing
until it contacts the carburetor to make sure the dia-
phragm lip is properly seated in the groove in the
carburetor. If the diaphragm is not properly seated,
leakage will occur.
8. Place the jet needle, spring seat, and spring into
the vacuum piston; then place the assembly down
into the carburetor.
9. Place the top cover into position; then secure with
the Phillips-head screws. Tighten securely.
Back
4-6
CC749
CC748
CC746
Back to TOC
INSTALLING
1. Place the carburetor into position on the engine;
then connect the electric choke connector to the
main harness.
2. Connect the throttle cable to the carburetor.
Tighten the jam nut securely.
3. Connect the gas hose; then connect the carburetor
float chamber vent hose.
4. Place the carburetor into the intake boot and
tighten the clamp securely.
5. Install the inlet boot between the air filter housing
and the carburetor; then tighten the clamps
securely.
6. Install the left-side seat-base; then install the cen-
ter console and the seats making sure the seats
lock securely.

Engine RPM (Idle)

To adjust idle RPM, see Section 2.

Gas Tank

! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
REMOVING
1. Remove the seats and center console; then remove
the left-side and right-side seat-bases.
2. Remove twelve cap screws and two self-tapping
screws securing the floorboard to the frame.
Back to Section TOC
CH015D
Next