Arctic Cat WILDCAT/X Service Manual page 130

5. Holding the upper A-arm/ball joint down into the
knuckle, remove and discard the retaining cap screw.
6. Raise the upper A-arm to dislodge the ball joint from
the knuckle; then tip the knuckle outward and remove
the axle from the knuckle.
Wildcat/X
128
7. Push in on the axle shaft while pulling outward on the
axle coupler and remove the axle assembly from the
differential.
WC269
8. On the Wildcat/X from underneath the vehicle,
remove the carrier bearing support bracket; then
remove the bolts and nuts securing the carrier bearing
to the bracket and remove the bracket.
WC271
WC235
9. Disconnect the drive line coupler by removing three
nuts from the Allen-head bolts; then separate the drive
line to allow the front shaft to move rearward.
WC272
PR729C
WC265A
WC266A