Arctic Cat WILDCAT/X Service Manual page 46

17. Remove the ECT connector (A), front coil primary con-
nector (B), TPS connector (C), MAP/IAT connector (D),
and ISC connector (E); then tie the engine harness out of
the way.
18. Remove the engine ground cable.
19. Loosen the throttle body boot clamp; then remove the
throttle body leaving the throttle cable attached.
44
20. Remove the E-clip (A); then loosen the jam nut (B)
and slide the shift cable out of the mounting bracket
and off the shift arm (C).
WC204A
21. Disconnect the speed sensor connector (D), stator con-
nector (E), and crankshaft position sensor (F) and tie
the lower harness out of the work space.
WC206A
22. Remove the rear exhaust pipe and account for a gra-
foil gasket.
23. Remove the upper rear lateral link pivot bolt; then
drop the link down to allow removal of the rear drive
gear case through-bolt.
WC211A
WC210A
WC362A
WC364A
WC169A