Arctic Cat WILDCAT/X Service Manual page 148

3. Remove the brake calipers from the knuckles.
4. Leaving the lower trailing arm connected to the
knuckle, remove the upper trailing arm and lateral
links from the knuckle; then move the top of the
knuckle outward and rotate forward to disengage the
axle from the axle bearing.
146
5. Remove the rear axles from the rear drive gear case by
pushing the axle shaft toward the gear case and pull-
ing the CV/spline shaft out. Account for one O-ring on
each axle shaft.
WC240B
6. Remove the two lower lateral links from the frame;
then remove the lower rear gear case mounting cap
screw.
WC304
WC282B
7. Remove the lower frame gear case bracket; then
remove the left upper lateral link and the upper rear
gear case through-bolt.
WC286A
PR729C
WC287A
WC170B