Arctic Cat WILDCAT/X Service Manual page 176

12. Quickly pass the torch over the assembly to raise and
eliminate air bubbles. Slowly insert the bearing
assembly into the body allowing air to escape.
 NOTE: It is normal for some oil to overflow.
13. Depress the bearing assembly just past the retaining
wire groove. Install the retaining wire.
174
14. Push down on the IFP to seat the bearing assembly.
Remove the IFP screw.
FX091
15. Add sufficient oil to the reservoir to allow resetting of
the IFP. Reset the IFP to its specified height.
FX090
FX089
16. Install the IFP screw with O-ring. Wipe any excess oil
from the reservoir.
FX088
FX087
FX086
FX085
FX084