Shift Lever/Shift Cable; Hydraulic Brake System - Arctic Cat WILDCAT/X Service Manual

Shift Lever/Shift Cable

CHECKING
Turn the ignition switch on; then shift the transmission into
park. The letter P should illuminate on the LCD gauge and
the park icon (P) should illuminate. The vehicle should not
be able to move.
Move the shift lever all the way forward. The letter L
should illuminate on the LCD gauge.
If either park or low range cannot be reached, the shift
cable must be adjusted.
ADJUSTING
 NOTE: Shift cable adjustment should not be neces-
sary unless replacing the shift cable or shift lever.
1. Remove the seats; then remove the battery cover and
center console.
2. Loosen adjuster nut (A) and jam nut (B) and adjust the
cable as necessary to obtain park in the full aft posi-
tion of the shift lever and low range full forward.
Tighten the jam nut securely.

Hydraulic Brake System

CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at the
factory. To check and/or bleed a hydraulic brake system,
use the following procedure.
WC033A
1. With the master cylinder in a level position, check the
fluid level in the reservoir. If the level in the reservoir
is not above the MIN, add DOT 4 brake fluid.
WC094
2. Depress the brake pedal several times to check for a
firm brake. If the brake is not firm, the system must be
bled.
3. To bleed the brake system, use the following proce-
dure:
A. Remove the cover and fill the reservoir with DOT
4 brake fluid.
B. Install and secure the cover; then slowly press the
brake pedal several times.
C. Install one end of a clear hose onto the bleed screw
farthest from the cylinder (right rear) and direct the
other end into a container; then while holding
slight pressure on the brake pedal, open the bleed
screw and watch for air bubbles. Close the bleed
screw before releasing the brake pedal. Repeat this
procedure until no air bubbles are present.
WC348C
PR095
13