Arctic Cat WILDCAT/X Service Manual page 74

2. Remove the cover, spring, and nylon shift stop.
 NOTE: Some models were produced without a shift
stop and instead feature a threaded nut. At this point
on these models, no further disassembling should be
performed. For models with a shift stop, proceed to
step 3.
72
WC658
3. Remove the windage plate; then position the drive
clutch over an appropriate clutch holder.
 NOTE: The holder should either be secured in a vise
or bolted to a sturdy work bench.
WC657
4. Secure the drive clutch to the holder using the clutch
bolt and washer.
WC656A
5. Remove the lock nuts from the cam arm pivot pins;
then remove the pins and account for six thrust wash-
ers and three cam arms.
GZ529
FC083
FC084