Accelerator Pedal; Shift Lever - Arctic Cat WILDCAT/X Service Manual

Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 6 mm (1/4 in.) greater than
the rear measurement (toe-out).
To adjust the wheel alignment, use the following proce-
dure.
1. Center the steering wheel; then using an open-ended
wrench on the tie rod flat (A), loosen the inner and
outer jam nuts (B) on both tie rods.
CAUTION
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.
2. Turn the left-side and right-side tie rods in equal incre-
ments to achieve the proper toe-out; then tighten the
jam nuts to 10 ft-lb.
28

Accelerator Pedal

REMOVING
Dislodge the throttle cable holding grommet from the actu-
ator arm; then remove two torx-head screws and nuts
securing the accelerator pedal assembly to the splash panel
and remove the accelerator pedal.
PR087A
WC012A
INSTALLING
Align the mounting holes with the holes in the splash panel
and secure with the two torx-head screws and nuts; then
snap the throttle cable holding grommet into the actuator
arm.
REMOVING
1. Remove the seats; then remove the battery cover and
WC110B
shift lever handle.
2. Remove the center console leaving the shift lever boot
in the console.
3. Remove the nut from the shift cable pivot bolt; then
remove the four machine screws from the shift lever
axle mounting and remove the shift lever.

Shift Lever

PR709
PR342C