Arctic Cat WILDCAT/X Service Manual page 44

6. Remove the cargo box; then disconnect the gasline
hose connector from the fuel pump and separate the
fuel pump/level sensor connector.
7. Disconnect the taillight/brakelight connectors; then
carefully pry the wire harness anchors from the cross
members. Mark the location of and remove the nylon
tie.
8. Remove the springs from the exhaust pipe to muffler
connectors and remove the muffler. Account for two
grafoil seals.
42
WC186
9. Remove the two cargo box supports; then remove the
heat shield leaving the rear coil attached to the radia-
tor assembly.
WC179A
10. Remove the gas tank hold-down and gas tank; then
remove the gas tank cradle.
11. Disconnect the cooling fan connectors, spark plug
wire, and coil primary connector; then clamp off the
coolant hoses at the water pump and thermostat outlet.
Do not remove the hoses yet.
WC179B
WC153A
WC352A
WC350A