Arctic Cat WILDCAT/X Service Manual page 71

7. Install the shift shaft into the crankcase making sure
the washer is properly located; then align the timing
reference marks and completely seat the shift shaft.
8. Apply grease to the lips of the shift shaft seal in the
shifter housing; then using a new gasket, install the
shifter housing and secure with the cap screws.
Tighten in a crisscross pattern to 8 ft-lb.
9. With the O-ring lightly coated with grease and prop-
erly positioned, install the water pump. Secure using
the two existing cap screws.
 NOTE: The longer cap screw goes on the top of the
water pump.
FW-019
10. Install the coolant hoses and secure with the hose
clamps.
11. Install the spacer washer on the crankshaft; then
install the starter ring gear.
H2-026
H2-013A
12. Place the key into the keyway in the crankshaft; then
wipe all oil from the crankshaft surface and rotor/fly-
wheel bore and install the rotor/flywheel onto the
crankshaft aligning the keyway with the key. Secure
with the nut (coated with red Loctite #271) tightened
to 105 ft-lb.
GZ230A
GZ249
GZ226
69