Arctic Cat WILDCAT/X Service Manual page 140

5. On the Wildcat/X, secure the carrier bearing support
bracket to the frame with four cap screws and tighten
to 20 ft-lb.
6. Make sure the drive coupler boot is fully in place on the
differential drive coupler; then secure with the clamp.
 NOTE: To secure the clamp, use Hose Clamp Pliers.
7. Using new O-rings with clean grease applied, install
the front drive actuator on the differential and tighten
the three mounting screws securely. Connect the front
drive actuator connector.
8. Apply fresh multi-purpose grease to the splines; then
install the front axles into the differential pushing in on
the axle shafts to seat the splines into the differential.
138
WC266A
9. Install the axles into the knuckles; then swing the
knuckles vertical and engage the ball joint shanks into
the knuckles. While holding the ball joint securely in
the knuckle, secure with a new "patch-lock" cap
screw. Tighten to 35 ft-lb.
WC265A
WC275A
10. Install the hub assemblies onto the axles; then apply
Loctite primer and red Loctite #277 to the axle threads.
11. Engage the hub nut into the Belleville washer on the con-
vex side; then with the concave side of the washer directed
toward the hub, install the nut and washer. Keeping the nut
and washer engaged, tighten the hub nut to 250 ft-lb.
PR729C
WC272
WC271