Driveshaft (Wildcat 4/4X) - Arctic Cat WILDCAT/X Service Manual

12. Install the brake calipers and secure with new "patch-
lock" cap screws. Tighten to 20 ft-lb.
13. Install the hub plate and wheel onto each hub; then
using a crisscross pattern, tighten the wheel nuts in 20
ft-lb increments to a final torque factor of 80 ft-lb.
 NOTE: If the hub plate cannot be fully installed due
to misalignment of the nut, tighten the nut until prop-
erly aligned and the plate is fully seated.
14. Tighten the differential drain plug to 45 in.-lb; then
remove the fill/level plug.
15. Pour in the recommended grade and amount of lubri-
cant until the lubricant shows on the threads of the
level hole; then install the fill/level plug and tighten to
16 ft-lb.
16. Install the hub caps; then install the forward belly
panel. Remove the jack stands, and lower the vehicle.

Driveshaft (Wildcat 4/4X)

REMOVING/DISASSEMBLING
1. Remove the front and rear seats.
WC303A
2. Remove the battery access panel, shift knob, front
and rear console, and front seat belts. Make sure to
disconnect the reverse override switch and the front
and rear accessory plugs.
WC268A
3. On the rear driveshaft coupler near the rear differen-
tial, remove the three rearward-facing Allen-head
screws.
WC317A
4. On the front driveshaft coupler, remove the three for-
ward-facing Allen-head screws and nuts along with
one rearward facing Allen-head screw and nut.
Remove the driveshaft. Remove the remaining
Allen-head screws and nuts.
WC722A
WC721A
WC716
139