Arctic Cat WILDCAT/X Service Manual page 145

7. Remove the rear axles from the rear drive gear case by
pushing the axle shaft toward the gear case and pull-
ing the CV/spline shaft out. Account for one O-ring on
each axle shaft.
REMOVING FRONT DRIVE AXLE
 NOTE: For removing a front drive axle, see Front
Differential in this section.
CLEANING AND INSPECTING
AXLES
 NOTE: Always clean and inspect the drive axle com-
ponents to determine if any service or replacement is
necessary.
1. Using a clean towel, wipe away any oil or grease
from the axle components.
WC282B
2. Inspect boots for any tears, cracks, or deterioration.
 NOTE: If a boot is damaged in any way, it must be
replaced with a boot kit.
DISASSEMBLING AXLES
 NOTE: Only the boots are serviceable on the axles;
if any other component is worn or damaged, the axle
must be replaced.
1. Using CV Boot Clamp Tool, remove and retain both
clamps for assembly purposes.
WC286A
2. Place the white-striped end of the CV joint into a
vise.
PR729C
3. To disengage the axle from the CV joint, sharply pull
back on the axle; then slide the boot off of the axle.
CD019
CF337
CF335
143