Arctic Cat WILDCAT/X Service Manual page 22

3. Unplug the two connectors from the EPS unit; then
remove four cap screws and two lock nuts from the
steering flex-shaft clamp bracket and clamp.
4. Remove the U-clamp; then remove the bracket.
5. Loosen the Allen-head cap screw securing the steering
rack input coupler to the shaft; then remove four cap
screws securing the EPS mounting bracket to the frame.
20
WC241A
6. Remove the mounting screw securing the brake line
support bracket to the EPS mounting bracket.
7. Remove the steering flex-shaft support bracket; then
slide the EPS unit upwards and to the rear until clear
of the steering rack input coupler.
WC242A
8. Remove the steering flex-shaft coupler from the EPS
unit; then maneuver the assembly past the brake hoses
and out of the vehicle.
WC242A
9. Remove the four cap screws securing the EPS mount-
ing bracket to the EPS unit.
 NOTE: No repairs are authorized on the EPS assem-
bly and it must be replaced as a complete assembly.
INSTALLING
1. Install the EPS mounting bracket onto the EPS unit
and secure with the four cap screws. Tighten to 35 ft-
lb.
WC245A
WC246A
WC247A
WC253A