Arctic Cat WILDCAT/X Service Manual page 149

8. Remove the lower front through-bolt; then remove the
boot clamp on the input drive coupler and slide the
gear case to the rear until drive coupler disengages.
AT THIS POINT
On the Wildcat 4/4X if the technician's objective is to
remove the rear driveshaft, release the clamp secur-
ing the shaft to the gear case; then slide the shaft
from the gear case.
WC169A
9. Lay the gear case on its left side and remove from
either side of the vehicle. Account for the spring and
washer with the drive coupler.
WC170C
RING GEAR/THRUST BUTTON
Removing
1. Remove the cap screws securing the gear case cover
to the gear case; then remove the ring gear.
2. Remove the thrust button from the gear case cover
(left-hand threads). Account for a shim.
Inspecting
1. Inspect the ring gear for excessive wear, missing or
chipped teeth, or discoloration.
2. Inspect the thrust button for excessive wear or discol-
oration.
WC288A
3. Inspect the bearings for discoloration, roughness, or
excessive wear.
 NOTE: For servicing bearings or seals, see Front
Differential in this section.
Installing/Shimming
 NOTE: Ring gear clearance must be adjusted prior
to selecting shim for the thrust button.
1. Install the thrust button with shim into the gear case
cover and tighten securely (left-hand threads).
WC743
WC290
147