Arctic Cat WILDCAT/X Service Manual page 143

12. On the front driveshaft by the front differential,
remove the rear-most boot clamp. Account for an O-
ring on the splined end of the shaft.
13. Slide the shaft rearward through the bearing housing
and remove the shaft.
ASSEMBLING/INSTALLING
1. Apply a small amount of grease to the splines; then
slide the front driveshaft through the front bearing
housing and into the boot on the front differential.
Tighten clamp securely.
2. Apply a small amount of grease to the splines; then
slide the center driveshaft into the boot connecting to
the front driveshaft. Secure both clamps. Do not
tighten the set screw at this time.
3. Using the existing hardware, connect the bearing
housing to the frame. Tighten to 35 ft-lb. Do not
tighten set screws at this time.
WC710
4. Place the rear driveshaft in position; then using new
Allen-head screws, connect the front and rear cou-
plers. Starting with rear coupler, tighten to 40 ft-lb.
5. Remove the set screws on the front and rear bearing
housing and apply one drop of red Loctite #271.
Tighten to 75 in.-lb.
WC712
6. Install the front console making sure to connect the
reverse override switch and accessory plug.
7. Install the shift knob, battery access panel, rear con-
sole, and front seat belts. Make sure to connect the
rear accessory plug. Tighten the seat belt hardware to
60 ft-lb.
WC712
8. Using new cap screws, install the rear seats. Tighten
the screws to 15 ft-lb.
WC697A
WC699A
WC721A
141