Arctic Cat WILDCAT/X Service Manual page 42

21. Disconnect the speed sensor connector (D), stator connec-
tor (E), and crankshaft position sensor (F) and tie the
lower harness out of the work space.
22. Remove the rear exhaust pipe and account for a grafoil
gasket.
23. Remove the upper rear lateral link pivot bolt; then drop
the link down to allow removal of the rear drive gear case
through-bolt.
40
 NOTE: It may be necessary to use a hoist to slightly
raise the rear of the vehicle to free the link from the
frame weldment.
24. Remove two through-bolts and one cap screw secur-
ing the rear drive gear case; then reattach the lateral
link and remove the hoist if used.
WC362A
WC364A
25. Using a suitable engine lift and equalizer sling, sup-
port the engine; then remove the engine through-bolts,
front first followed by the rear.
WC169A
26. Remove the rear drive coupler boot; then lift the engine
slightly and work the rear drive gear case and engine rear-
ward enough to clear the front drive coupler and drop the
driveshaft down.
WC170
WC170A
WC169A
WC172A