Arctic Cat WILDCAT/X Service Manual page 80

 NOTE: It is critical to verify the seal on the bearing
faces the clutch cover seal before pressing in a new
bearing.
3. Secure the bearing in the clutch cover using the exist-
ing bearing retainers and machine screws (threads
coated with blue Loctite #242). Tighten to 8 ft-lb.
4. With the gasket and alignment pins in position, install
the clutch cover and secure with the existing cap
screws. Tighten to 8 ft-lb.
5. Making sure the alignment pins are correctly installed,
place a bead of silicone sealant on the mating surfaces
of the V-belt housing and install the housing. Using
new "patch-lock" cap screws, secure the housing and
tighten the screws to 8 ft-lb.
78
GZ501
6. Place the fixed driven sheave onto the driveshaft; then
install the V-belt making sure the directional arrow is
facing the direction of engine rotation.
GZ508
GZ528A
7. Making sure the "X" marks are properly aligned,
install the movable drive sheave and secure with the
cap screw (A), washer (B), and shim(s) (C). Tighten to
60 ft-lb.
GZ532A
GZ531A
WC809
WC667