Arctic Cat WILDCAT/X Service Manual page 100

19. Install the gas tank cradle and gas tank and secure
with the hold down bracket; then connect the fuel hose
and fuel pump/fuel level sensor connector.
20. Install the heat shield and secure with the appropriate
fasteners; then install the cargo box supports and
secure with the cap screws and new lock nuts. Tighten
to 20 ft-lb.
21. Install the muffler and secure with the spring; then
tighten the front and rear exhaust pipe cap screws to
20 ft-lb.
22. Secure the rear wiring harness to the cargo box sup-
ports as indicated and connect the tail/brakelight con-
nectors to the light housings.
23. Remove the plug on the radiator and fill the radiator
with the recommended coolant allowing air to bleed
from the loosened filler cap; then loosen the bleed
screw on the water pump allowing air trapped in the
engine to escape. Top off coolant and tighten all bleed
points securely.
98
WC179B
24. Install the cargo box; then remove the cap from the
gas fill hose and place the rear body panel into posi-
tion. Secure the gas tank fill hose to the filler neck and
secure with the clamp.
25. Secure the rear body panel with the appropriate fas-
teners; then pour in the prescribed engine oil and con-
nect the negative battery cable. Install the battery
cover and rear seats.
26. Start the engine allowing it to warm up for a few min-
utes; then shut the engine off and check for leaks.
Check all fluid levels and correct as necessary.
27. Install the rear center console; then install the seat belt
anchors and rear splash panels
WC354A
WC205A