Table of Contents
Advertisement
8 Access and configuration
66
Symbol
Pay particular attention to the following message:
"Warning: Changes not supported by the Setup Tool!" If you change them with the
GUI, this can cause inconsistencies or malfunctions. Therefore, it is recommended that
the configuration is continued with the Setup Tool.
8.3.1.3 GUI menus
The configuration options of your device are contained in the sub-menus, which are dis-
played in the navigation bar in the left-hand part of the window.
Note
Please note that not all devices have the full range of functions. Check the software of
your device on the corresponding product page under
8.3.2 SNMP shell
SNMP (Simple Network Management Protocol) is a protocol that defines how you can ac-
cess the configuration settings.
All configuration settings are stored in the MIB (Management Information Base) in the form
of MIB tables and MIB variables. You can access these directly from the SNMP shell via
SNMP commands. This type of configuration requires a detailed knowledge of our devices.
8.4 BOOTmonitor
The BOOTmonitor is only available over a serial connection to the device.
The BOOTmonitor provides the following functions, which you select by entering the cor-
responding number:
(1) Boot System (reboot the system):
The device loads the compressed boot file from the flash memory to the working
memory. This happens automatically on starting.
Meaning
This symbol appears in messages referring you to settings
that were made with the Setup Tool.
This symbol appears in messages referring you to the fact
that values were entered or selected incorrectly.
www.teldat.de
.
bintec Rxxx2/RTxxx2
Teldat GmbH
Hide quick links:
Advertisement
Table of Contents
