Teldat bintec R3002 Manual page 162

Table of Contents

The menu Advanced Settings consists of the following fields:

Fields in the Advanced Settings menu.

DHCP MAC Address

DHCP Hostname

DHCP Broadcast Flag

This option only applies for routing interfaces. Assign the inter-

face to a VLAN by entering the VLAN ID of the relevant VLAN.

Possible values are

(default value) to

Only for Address Mode =

If Use built-in is activated (default setting), the hardware MAC

address of the Ethernet interface is used. In the case of physical

interfaces, the current MAC address is entered by default.

If you disable Use built-in, you enter an MAC address for the

virtual interface, e.g.

Some providers use hardware-independent MAC addresses to

allocate their clients IP addresses dynamically. If your provider

has assigned you a MAC address, enter this here.

Only for Address Mode =

Enter the host name requested by the provider. The maximum

length of the entry is 45 characters.

Only for Address Mode =

Choose whether or not the BROADCAST bit is set in the DHCP

requests for your device. Some DHCP servers that assign IP

addresses by UNICAST do not respond to DHCP requests with

the set BROADCAST bit. In this case, it is necessary to send

DHCP requests in which this bit is not set. In this case, disable

this option.

The function is activated by selecting

The function is enabled by default.

Select whether your device is to respond to ARP requests from

its own LAN on behalf of defined remote terminals.

The function is activated by selecting

bintec Rxxx2/RTxxx2

Show Quick Links

Table of Contents