Teldat bintec R3002 Manual page 512

21 Local Services
498
Note
This interface is used to transmit the BRRP advertisement data packets and possibly
to transmit keepalive monitoring data packets. Another interface must be configured in
the next step to transmit the usage data.
Configuration of the advertisement interface is performed in the Local Services->BRRP-
>Virtual Router->New menu under BRRP Advertisement Interface.
Only the active router in the router group sends advertisement data packets. The IPv4
multicast address 224.0.0.18 is used as the destination address for all routers in the
group. All passive routers in the group must monitor this address so that if the advertise-
ment data packets are not received that can react according to their priority and BRRP
configuration.
• Configuration of the interface for transmitting usage data (configuration of the virtual in-
terface).
A virtual interface is activated and deactivated by assigning it to a virtual router over the
BRRP router redundancy protocol.
Configuration is performed in the Local Services->BRRP->Virtual Router->New->Eth-
ernet Interface menu.
In this step, you configure the IP address settings and assign the interface to a virtual
router. The properties of the virtual router (e.g. the priority) are also defined here.
Note
The system automatically assigns the MAC address of the virtual interface according
to the following model: 00:00:5E:00:01:<ID of the virtual router>. The ID of the virtual
router therefore determines the MAC address of the interface, which is used to trans-
mit the usage data.
The configuration of the virtual interface (MAC address, IP address) and the configura-
tion of the virtual router (sending interval for advertisement, master down trials) must
be identical on all routers with the same virtual router ID within the logical group.
You must use IP addresses from different subnets for the advertisement interface and
for the virtual interface.
All virtual interfaces on a physical router should normally have the same priority.
• Configuration of the synchronisation between the virtual router and configuration of the
Teldat GmbH
bintec Rxxx2/RTxxx2