Table of Contents
Advertisement
17 WAN
280
Field
Create NAT Policy
Local IP Address
Route Entries
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field
Block after connection
failure for
Maximum Number of
Dialup Retries
Description
defined as the default route.
The function is enabled with
The function is enabled by default.
Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with
The function is enabled by default.
Only for IP Address Mode =
Assign an IP address from your LAN to the PPT interface, which
is to be used as your device's internal source address.
Only if IP Address Mode =
Define other routing entries for this PPTP partner.
Add new entries with Add.
•
: IP address of the destination host or
network.
•
: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
•
: The lower the value, the higher the priority of the
route (range of values ...
Description
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is
.
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are
to
.
.
). The default value is .
.
bintec Rxxx2/RTxxx2
Teldat GmbH
Hide quick links:
Advertisement
Table of Contents
